Thermoplastic Trucks

• Boss 250 CFM utility mount air compressor - tier 4
  • Air Dryer system with secondary water traps on bead tanks

• PTO driven hydraulic pumps mounted on to chassis transmission
• Foldable steel guide wheel assembly, movable to both sides of the truck, with hydraulically driven up and down control
• Hydraulically actuated, heavy duty, machined tube gun-carriage assemblies laterally controlled by the use of a steering wheel mounted near each operator seat - 40” extension both sides
• Hydraulically actuated parallel-arm style gun carts
• (1) high volume hot oil pump/motor combo
• (2) 2” oil-jacketed positive displacement material pumps off the Centerline and Edge Line rear kettles
  • Proportionally controlled from timing system
• (2) hydraulic knife valves mounted at each material pump inlet to open or close flow from kettle
• Hydraulically driven agitator in each melter/kettle with forward and reverse control
• Creep Drive Option Available

• Over cab light bar/beacon, front, mid bed and rear strobe lights
• Rear facing 4’ by 8’ electrically actuated 25 light arrow board
• Night light package including forward facing work lights over cab, grille mounted light bar, lights to illuminate carts, material deck work lights and perimeter lighting
• Digital temperature displays by each melter
• Reverse and Deck camera
• Wired David Clark 3 station intercom system
• Rear operator station on operator platform
• Skip-Line timing system with footage counter and in-cab digital speedometer
• Camera guidance system

• (4) 3,000lb diesel fired melters with safety vents
  • 12" heat dome in each melter
  • Crossover plumbing between front melters
• (2) ASME certified 2,500lb capacity bead tanks
  • Venturi vacuum load on each tank, exhausted below the deck with mufflers

• Manually operated valving to isolate hot oil by color/truck side
• Oil-jacketed hoses from pump outlet to cart mounted material filter
• Oil-jacketed hose from filter outlet to gun inlet
• Oil wrapping around valving and filters as needed to keep material hot
• Air blowdown system to remove material from pump and related material hoses after striper use
• Material recirculation system from cart mounted filter back to kettle top to aid in material heating

Left Hand (CL):

• (2) 6" ribbon/spray thermo guns
• (2) linear actuators to raise and lower each gun for precise control of line width
• (2) Arrow drop on beaders
• (2) blow air nozzles mounted directly in front of each gun

Right Hand (EL):

• (1) 6" ribbon/spray thermo gun
• (1) linear actuators to raise and lower each gun for precise control of line width
• (1) Arrow drop on beaders
• (1) blow air nozzles mounted directly in front of each gun

• Heavy-duty platform for material storage with hinged side doors and railings
• Rear operator’s platform providing full view of carriages and melters
  • Centrally mounted electrical console housing pertinent switches and displays
• Full backed bucket seats with toolbox storage below
• Ancillary fuel tank to run burners